Technical Support Tree

No Light Emitting from the Bulb solution:

If no light is emitting from the bulb on your scanner make sure that your BIOS is properly configured. You can do this by following this guideline:

Common BIOS Entry Methods and Settings:

BIOS Setup Keys

Computer Brand

Parallel Port Settings

F1	IBM Aptiva (under device I/O)	3bc Bi-directional or 378/ECP/EPP 1.9 use DMA 3 278h/Compatible
F10	Compaq (under setup/communication)	3bc=3be, 7bc-7be, IRQ 7 DMA 3** 278-27F, 678-67a, IRQ 7 DMA 3 378 EPP or ECP mode(newer models)
F3 Then F1	Sony Desktop	378h EPP or ECP mode DMA 3
Crtl+Alt+Esc/F9 or Del	Acer (under system security)	378h EPP or ECP DMA 3
F2	Sharp Laptop	378h EPP or ECP DMA 3
Del/F1 or F2	Micron	378 EPP or ECP DMA 3
F2	IBM Laptop	EPP or Compatible
F1/F2 or Del	Packard Bell	378h EPP or ECP, 3bc Bi-directional**
F1 or Del	Gateway	378h EPP or ECP DMA 3 or 3bc Bi-directional**
F1	Hewlett Packard	378h EPP or ECP DMA 3 or 3bc Bi-directional**
F1/Del/F2 or Crtl+Alt+Enter	Dell	378h EPP or ECP DMA 3. Parallel port must be set to Enabled and not on Auto
Function +F1	Dell Latitude Laptop	378h EPP or ECP DMA 3. Parallel port must be set to Enabled and not on Auto
Crtl+Alt+Esc or Del	AST (under system security)	378h EPP or ECP DMA 3
Del or F1	NEC	378h EPP or ECP DMA 3
F1 or Del	Cloned/PC Compatible	378h EPP or ECP DMA 3
Toshiba Utility and or Hardware (under program group) or F1	Toshiba Laptop	Output Only/Compatible or PS Bi-directional

If the BIOS is configured properly and you are still not getting any light from the bulb, check the AC connection and determine whether it is warm or cold to the touch. If the connection is okay and everything seems to be plugged in it is possible that you have a bad bulb or that the bulb burned out. In this case please call to talk with a representative about a replacement.

 

Back to Top